WatchFitTool
Noise Colorfit Pro 2 — case dimensions and design

Noise · 2019

Colorfit Pro 2Size, Dimensions & Wrist Fit

Case Width

35.7mm

Thickness

11.6mm

Lug-to-Lug

40.9mm

Weight

36.3g

The Noise Colorfit Pro 2 sits best on flat wrist widths of about 43–58mm (≈ 11.5–15.5cm wrist circumference). Adjust the slider below to check your wrist.

Affiliate disclosure: As an Amazon Associate, WatchFitTool earns from qualifying purchases. If you buy through links on this page, we may earn a commission at no extra cost to you. Learn more.

The Colorfit Pro 2 in short

The figures that decide whether this watch suits you, pulled out of the full specification sheet further down.

  • Rated for 10 days of use per charge.
  • Water rated to 1.5 m.
  • 11.6mm thick. Thicker than 79% of 36mm watches — it will sit noticeably high on the wrist.
  • 1.3 inches LCD display.

Does the Colorfit Pro 2 fit your wrist?

Drag the slider to your wrist width and see the Colorfit Pro 2 overlaid at true scale. Lug-to-lug — not case diameter — decides whether a watch overhangs your wrist.

Fit tool

Watch Fit Tool

For sports watches, lug-to-lug (L2L) is what matters most — it decides whether a watch overhangs your wrist. Bulky is fine; overhang is not.

Your wrist
mm
≈ 146.9mm around

Noise Colorfit Pro 2

Case 40.9mm · Lug-to-lug 40.9mm · Thickness 11.6mm · 36g

Balanced Fit

40.9mm on a 55mm wrist

10:09TUE 12lug to lug 40.9mmyour wrist 55.0mm

Comfortably inside the edges of your wrist, and it seats and sits low enough to wear without thinking about it.

On a 55mm wrist the sweet spot is 47–53mm lug to lug. This one is 40.9mm, so you could go bigger.

How to Measure

Measure where you wear it, just below the wrist bone. Either of these works — the tool converts between them.

  1. 1. Flat width — arm flat on a table, palm up. Measure straight across the top of the wrist, bone to bone, ignoring the curve down the sides.
  2. 2. Around — a tape, or a strip of paper marked and held against a ruler, snug the whole way round.
Complete Wrist Measurement Guide →
Against one you know

Leather: Attaches at the lugs, so the case back rests on your skin. Thins and softens with wear. Typical figures, not this model’s own.

Show the measurements
  • Across the wrist7.1mm spare each side

    Comfortable, with visible skin either side.

  • Off the wrist11.6mm off the skin

    Normal sports-watch height for a wrist this size. (11.6mm case, back against the skin)

  • How it seats~3.7mm under the rim

    Seats well, with the case back following most of the wrist.

  • Weight on the wrist36g

    Light enough to forget you have it on. (0.7g per mm of wrist)

Happy with the fit? Check current availability for the Colorfit Pro 2.

Check offer

2D Dimension Schematics

The Colorfit Pro 2 drawn to scale — from above, and in profile against the wrist.

Highlight
From above — true scale
From the side — how far it sits off the wrist
  • Noise Colorfit Pro 235.7mm × 40.9mm · 11.6mm thick

3D preview

Noise Colorfit Pro 2 on a wrist

On an arm sized to your own wrist — the view a product photo never gives you.

Open 3D try-on

Shapes are built from published measurements, not manufacturer 3D models — accurate proportions, generic dial.

Colorfit Pro 2 battery life

The runtime the manufacturer publishes for everyday use.

  • Smartwatch10 days
Charges in 2 hours

How the Colorfit Pro 2 ranks on battery

Against the 38 Noise watches in our database, ranked on each figure Noise publishes.

  • Everyday use10 days#2 of 38
  • Capacity210 mAh#27 of 28

Top three in the Noise range for everyday (smartwatch) use.

Colorfit Pro 2 specifications

The figures that decide a purchase, followed by every line Noise publishes.

Battery life
10 days
Display
1.3 inches
Resolution
240 x 240 px
Water rating
Waterproof
Charging
2 hours

Full specification sheet

82 published lines across 8 groups, unedited

Design

width
35.7
height
40.9
volume
16.94 cm³
weight
36.3 g
thickness
11.6
resolution
240 x 240 px
screen size
1.3 inches
Display type
LCD
Has a display
pixel density
261 ppi
water resistance
Waterproof
Always-On Display
has a touch screen
waterproof depth rating
1.5 m
Watch band is replaceable
Has sapphire glass display
Ingress Protection (IP) rating
IP68
has branded damage-resistant glass

Battery

charge time
2 hours
battery life
10 days
battery power
210 mAh
has wireless charging
has a removable battery
Has a solar power battery
has a rechargeable battery

Sensors

has GPS
has a compass
Has a barometer
has a gyroscope
Has a cadence sensor
has an accelerometer
Monitors perspiration
Has a heart rate monitor
Has a temperature sensor
Monitors blood oxygenation levels

Features

release date
2019-09-30
Has a stopwatch
Has smart alarm
warranty period
1 years
Has call control
Has silent alarm
Has notifications
Locates your phone
has voice commands
Acquires GPS faster
Has vibrating alerts
Can be used to answer calls
Has a built-in camera remote control function

Connectivity

has NFC
supports ANT+
supports Wi-Fi
Bluetooth version
5
has a cellular module
Is compatible with iOS
Is compatible with Android

Miscellaneous

maximum Bluetooth range
10 m
Is compatible with Windows
Is compatible with Mac OS X
has an external memory slot
has a battery level indicator
has a socket for a 3.5 mm audio jack

App & Software

Has achievements
Has goal setting
Has weight tracking
Tracks water intake
Has inactivity alerts
Provides activity reports
Counts how many calories you've burned

Activity tracking

Measures pace
Tracks distance
Tracks elevation
Designed for golf
Tracks your sleep
Tracks steps taken
Designed for diving
Has a route tracker
Has exercise tagging
Has multi-sport mode
Tracks calorie intake
Provides sleep reports
Detects activities automatically
Has a stroke counter for swimming

Colorfit Pro 2 — Frequently Asked Questions

Will the Noise Colorfit Pro 2 fit my wrist?

The Noise Colorfit Pro 2 looks balanced on flat wrist widths of roughly 43–58mm (about 11.5–15.5cm circumference). Drag the slider above to check it against your own measurement.

How long does the Noise Colorfit Pro 2 battery last?

Noise rates it at 10 days per charge in everyday use.

How does the Noise Colorfit Pro 2 battery compare with other Noise watches?

At 10 days in everyday use it ranks #2 of the 38 Noise watches in our database — the top 5% of the range. The full ranking, including GPS and power-saving figures, is on our Noise battery life comparison.

Is the Noise Colorfit Pro 2 thick for a 36mm watch?

At 11.6mm, thicker than 79% of 36mm watches — it will sit noticeably high on the wrist. Thickness, not case width, is what decides whether a watch catches on a shirt cuff.

What other watches are the same size as the Noise Colorfit Pro 2?

Zenith Defy Skyline 36 Stainless Steel - Diamond / Silver, Apple Watch Series 11 - GPS + Cellular · Aluminium · 42mm, TAG Heuer Aquaracer Professional 300 36 Stainless Steel / Blue Gradient - Diamond / Rubber, Tissot Seastar 1000 36 Quartz Stainless Steel - Rose Gold / Black / Bracelet all sit within half a millimetre of the Noise Colorfit Pro 2's 35.7mm case, so they cover the same amount of wrist.

What is the lug-to-lug of the Noise Colorfit Pro 2?

40.9mm, against a 35.7mm case width. Lug-to-lug is the measurement that decides overhang: if it exceeds the flat width of your wrist, the lugs sit past the edge no matter how modest the case diameter looks.