
Noise · 2022
Colorfit Pro 4 AlphaSize, Dimensions & Wrist Fit
Case Width
37mm
Thickness
12mm
Lug-to-Lug
45mm
Weight
41.7g
The Noise Colorfit Pro 4 Alpha sits best on flat wrist widths of about 47–64mm (≈ 12.6–17.1cm wrist circumference). Adjust the slider below to check your wrist.
Affiliate disclosure: As an Amazon Associate, WatchFitTool earns from qualifying purchases. If you buy through links on this page, we may earn a commission at no extra cost to you. Learn more.
The Colorfit Pro 4 Alpha in short
The figures that decide whether this watch suits you, pulled out of the full specification sheet further down.
- Rated for 7 days of use per charge.
- Water rated to Water resistant.
- 12mm thick. Thicker than 65% of 37mm watches — it will sit noticeably high on the wrist.
- 1.85 inches LCD display.
- Takes 22mm bands, so third-party straps fit without an adapter.
Does the Colorfit Pro 4 Alpha fit your wrist?
Drag the slider to your wrist width and see the Colorfit Pro 4 Alpha overlaid at true scale. Lug-to-lug — not case diameter — decides whether a watch overhangs your wrist.
Watch Fit Tool
For sports watches, lug-to-lug (L2L) is what matters most — it decides whether a watch overhangs your wrist. Bulky is fine; overhang is not.
Measure at the point where you wear your watch — typically just below the wrist bone.
Flat width — lay your arm on a table, palm facing up, and measure straight across the top of your wrist with a ruler. Bone to bone; do not follow the curve down the sides.
Around — wrap a tape measure snugly round the wrist. No tape? Wrap a strip of paper, mark the overlap and hold the strip against a ruler.
Width ≠ circumference. They are different numbers — around 170mm is about 64mm across — so set the toggle to whichever one you actually measured before you type it in.
Noise Colorfit Pro 4 Alpha
Case 45.0mm · Lug-to-lug 45.0mm · Thickness 12.0mm · 42g
Balanced Fit
45mm on a 55mm wrist
Comfortably inside the edges of your wrist, and it seats and sits low enough to wear without thinking about it.
On a 55mm wrist the sweet spot is 47–53mm lug to lug. This one is 45mm, so you could go bigger.
Measure where you wear it, just below the wrist bone. Either of these works — the tool converts between them.
- 1. Flat width — arm flat on a table, palm up. Measure straight across the top of the wrist, bone to bone, ignoring the curve down the sides.
- 2. Around — a tape, or a strip of paper marked and held against a ruler, snug the whole way round.
Leather: Attaches at the lugs, so the case back rests on your skin. Thins and softens with wear. Typical figures, not this model’s own.
Show the measurementsHide the measurements
- Across the wrist5.0mm spare each side
Comfortable, with visible skin either side.
- Off the wrist12.0mm off the skin
Normal sports-watch height for a wrist this size. (12.0mm case, back against the skin)
- How it seats~5.2mm under the rim
Seats well, with the case back following most of the wrist.
- Weight on the wrist42g
Light enough to forget you have it on. (0.8g per mm of wrist)
Happy with the fit? Check current availability for the Colorfit Pro 4 Alpha.
Check offer2D Dimension Schematics
The Colorfit Pro 4 Alpha drawn to scale — from above, and in profile against the wrist.
- Noise Colorfit Pro 4 Alpha37mm × 45mm · 12mm thick
3D preview
Noise Colorfit Pro 4 Alpha on a wrist
On an arm sized to your own wrist — the view a product photo never gives you.
Shapes are built from published measurements, not manufacturer 3D models — accurate proportions, generic dial.
Colorfit Pro 4 Alpha battery life
The runtime the manufacturer publishes for everyday use.
- Smartwatch7 days
How the Colorfit Pro 4 Alpha ranks on battery
Against the 38 Noise watches in our database, ranked on each figure Noise publishes.
- Everyday use7 days#4 of 38
- Capacity270 mAh#17 of 28
What size band does the Colorfit Pro 4 Alpha take?
Lug width
22mm
Any 22mm strap fits, so you are not restricted to Noise's own bands. Quick-release pins let you swap without tools — check that a replacement lists 22mm and quick-release before buying.
Affiliate disclosure: As an Amazon Associate, WatchFitTool earns from qualifying purchases. If you buy through links on this page, we may earn a commission at no extra cost to you. Learn more.
Colorfit Pro 4 Alpha specifications
The figures that decide a purchase, followed by every line Noise publishes.
- Battery life
- 7 days
- Display
- 1.85 inches
- Resolution
- 240 x 284 px
- Water rating
- Water resistant
- Strap
- 22 mm
- Charging
- 2 hours
Full specification sheet
94 published lines across 8 groups, unedited
Design
- width
- 37
- height
- 45
- volume
- 19.98 cm³
- weight
- 41.7 g
- thickness
- 12
- resolution
- 240 x 284 px
- screen size
- 1.85 inches
- Display type
- LCD
- Has a display
- pixel density
- 200 ppi
- width of band
- 22 mm
- water resistance
- Water resistant
- Always-On Display
- has a touch screen
- Watch band is replaceable
- Has sapphire glass display
- Ingress Protection (IP) rating
- IP68
- has branded damage-resistant glass
Battery
- charge time
- 2 hours
- battery life
- 7 days
- battery power
- 270 mAh
- has wireless charging
- has a removable battery
- Has a solar power battery
- has a rechargeable battery
Sensors
- has GPS
- has a compass
- Has a cadence sensor
- has an accelerometer
- Monitors perspiration
- Has a heart rate monitor
- Has a temperature sensor
- Monitors blood oxygenation levels
Features
- release date
- 2022-12-14
- Has a stopwatch
- Has smart alarm
- Has call control
- Has silent alarm
- Has notifications
- Has ECG technology
- Locates your phone
- has fall detection
- has voice commands
- Has vibrating alerts
- Can be used to answer calls
- has irregular heart rate warnings
- Has a built-in camera remote control function
Connectivity
- has NFC
- supports ANT+
- supports Wi-Fi
- supports Galileo
- Bluetooth version
- 5.3
- has a cellular module
- Is compatible with iOS
- Is compatible with Android
Miscellaneous
- Has passcode
- Has auto pause
- Is compatible with Windows
- Is compatible with Mac OS X
- has an external memory slot
- has a battery level indicator
- has a socket for a 3.5 mm audio jack
- Compatible with external heart rate monitors
App & Software
- Ad-free
- Free app
- Has coaching
- Has achievements
- Has goal setting
- Has exercise diary
- Predicts ovulation
- Can be personalised
- Has weight tracking
- Predicts start date
- Tracks water intake
- Has inactivity alerts
- Has period notifications
- Has temperature tracking
- Provides activity reports
- Displays fertile window notifications
- Counts how many calories you've burned
Activity tracking
- Measures pace
- Tracks distance
- Tracks elevation
- Designed for golf
- Tracks your sleep
- Tracks steps taken
- Designed for diving
- Has a route tracker
- Has exercise tagging
- Has multi-sport mode
- Tracks calorie intake
- Provides sleep reports
- Detects activities automatically
- Has a stroke counter for swimming
Alternatives to the Colorfit Pro 4 Alpha
Watches that cover a similar amount of wrist, with the measurements that separate them.

Noise
ColorFit Pro 4 GPS
- Width
- 37mm
- Thick
- 12mm
- Weight
- 41.7g

Noise
ColorFit Icon 3
- Width
- 36.5mm
- Thick
- 11mm
- Weight
- 53.5g

Noise
Vision 2 Buzz
- Width
- 37.5mm
- Thick
- 11.4mm
- Weight
- 41g

Noise
ColorFit Pro 4
- Width
- 38.1mm
- Thick
- 11.7mm
- Weight
- 24.1g

Noise
Colorfit Pro 2
- Width
- 35.7mm
- Thick
- 11.6mm
- Weight
- 36.3g

Noise
Colorfit Nav
- Width
- 38.5mm
- Thick
- 11mm
- Weight
- 40g
Colorfit Pro 4 Alpha — Frequently Asked Questions
Will the Noise Colorfit Pro 4 Alpha fit my wrist?
The Noise Colorfit Pro 4 Alpha looks balanced on flat wrist widths of roughly 47–64mm (about 12.6–17.1cm circumference). Drag the slider above to check it against your own measurement.
What size band does the Noise Colorfit Pro 4 Alpha take?
22mm. Any 22mm strap fits, so you are not limited to Noise's own bands — look for a quick-release fitting if you want to swap without tools.
How long does the Noise Colorfit Pro 4 Alpha battery last?
Noise rates it at 7 days per charge in everyday use.
How does the Noise Colorfit Pro 4 Alpha battery compare with other Noise watches?
At 7 days in everyday use it ranks #4 of the 38 Noise watches in our database — the top 11% of the range. The full ranking, including GPS and power-saving figures, is on our Noise battery life comparison.
Is the Noise Colorfit Pro 4 Alpha thick for a 37mm watch?
At 12mm, thicker than 65% of 37mm watches — it will sit noticeably high on the wrist. Thickness, not case width, is what decides whether a watch catches on a shirt cuff.
What other watches are the same size as the Noise Colorfit Pro 4 Alpha?
Zenith Defy A3643 Revival, Omega Museum Collection Seamaster Milano Cortina 2026 Winter Olympics, Kieslect Ks2, Xiaomi Redmi Watch 3 all sit within half a millimetre of the Noise Colorfit Pro 4 Alpha's 37mm case, so they cover the same amount of wrist.
What is the lug-to-lug of the Noise Colorfit Pro 4 Alpha?
45mm, against a 37mm case width. Lug-to-lug is the measurement that decides overhang: if it exceeds the flat width of your wrist, the lugs sit past the edge no matter how modest the case diameter looks.
